Our Favorite The Collapsible Bag Stand

This is a "weld free" metal stand. It packs great in a suitcase! (Fig. A.2).

These directions are for the typical 50-lb. bag approximately 17 inches (42.5 cm) wide by 30 inches (75 cm) long. Cut two lengths of %-inch (1.25 cm) or

%-inch (1.875 cm) wide, 1/8-inch (0.3 cm) thick flat metal stock, 80 inches (200 cm) long. Bend at the designated dimensions beginning at the bottom. Fit one hoop snugly inside the other. Overlap the top seams and tape with duct tape. Drill the holes for the pivot-point one inch (2.5 cm) above center. Tighten snugly to give it enough friction to stay upright without collapsing.

allow- 4" - 6" overlapof ends and-fasten- wHhm

Round- top screw with- he-ad- on- the inside- and- lock nut on the outside. Place flat washer between metal legs

6" narrower thaan faat width of bag

This measurement 1" narrower tham-fat width- of bag

6" narrower thaan faat width of bag allow- 4" - 6" overlapof ends and-fasten- wHhm

This measurement 1" narrower tham-fat width- of bag

Was this article helpful?

0 0
Greener Homes for You

Greener Homes for You

Get All The Support And Guidance You Need To Be A Success At Living Green. This Book Is One Of The Most Valuable Resources In The World When It Comes To Great Tips on Buying, Designing and Building an Eco-friendly Home.

Get My Free Ebook


Post a comment